Battery Cell - 12V
All hand trucks have a 500 lb. capacity, unless otherwise noted.
DUE TO FLUCTUATION IN FREIGHT COSTS, PLEASE CONTACT CUSTOMER SERVICE AT CUSTOMERSERVICE@MAGLINER.COM OR 1.800.624.5463 TO OBTAIN A FREIGHT QUOTE AND PLACE AN ORDER FOR THIS PRODUCT.
12v sealed gel battery cell. 5 AMP hour for powered stair climbing hand truck.
IMPORTANT BATTERY CHARGING NOTE: The battery must be charged within 3 months of storage to prevent self-discharge. If the battery is not charged within 3 months of storage, permanent loss of capacity may occur. If the powered product will be used regularly, it is recommended that the unit be kept on a charger whenever it is not in use; the batteries will not overcharge. If the powered product is going to be stored and/or not in regular use, the batteries must go through a full charge cycle every 2 weeks to ensure battery life and duty cycle.
Specs
*The “true” O.C.V. of a battery can only be determined after the battery has been removed from the load (charge or discharge) for 24 hours.
Based on these tables, if a battery is drained from fully charged to dead (12.8-11.8 every time), the projected lifespan is 200 charge cycles. If the motorized product uses 2 batteries, it is possible that the lifespan could be prolonged to 400 charge cycles.
If the AGM battery is not charged back up to 100% after use, the number of charge cycles will go down.
Remember: It takes the same amount of time to charge the complete capacity back into the battery as it does to take it out. So if the battery is used for 6 hours in a day and Open Charge Voltage is reduced from 12.8 to 11.8, the battery must be charged for a minimum of 6 hours to get that full 100% capacity back.